woodwirk

Overview

Bambu P1S

• BambuStudio Slicer (based on Prusa Slicer, Slic3r):
  • https://wiki.bambulab.com/en/software/bambu-studio/studio-quick-start
  • https://wiki.bambulab.com/en/x1/manual/introduction-to-bambu-studio (seems to be an older docs page)
• Wiki for Bambu P1S Printer:
  • https://wiki.bambulab.com/en/p1

This is the Bambu P1S interface:

Software

• OrcaSlicer (v2.1.1)

Procedure

SD card printing

1. Eject SD card from printer if necessary. There is an eject function in Settings > SD Card.
2. Transfer print file to SD card.
3. Use the down arrow on the interface to navigate to the files list. (You may need to navigate left to move through the side menu.)
4. Select the file for printing. It should be at the top of the list
5. Print

Troubleshooting

• Having issues like an offset first layer? Try using OrcaSlicer. It’s based on Bambu and Prusa slicers, so you can use it in the same way.
  https://github.com/SoftFever/OrcaSlicer
• Refer to the forum: https://forum.bambulab.com/

References

• https://wiki.bambulab.com/en/general/micro-sd-faq
• https://wiki.bambulab.com/en/x1/manual/print-from-sd-card